6th International Young Scientist Congress (IYSC-2021) and workshop on Intellectual Property Rights on 8th and 9th May 2021.  10th International Science Congress (ISC-2020) will be Postponed to 8th and 9th December 2021 Due to COVID-19.  International E-publication: Publish Projects, Dissertation, Theses, Books, Souvenir, Conference Proceeding with ISBN.  International E-Bulletin: Information/News regarding: Academics and Research

Anti-Surge Control Software Using General Purpose Programmable Single Loop Controller

Author Affiliations

  • 1ET and T Department, BIT, Durg, CG, India
  • 2ET and T Department, BIT, Durg, CG, India

Res. J. Engineering Sci., Volume 5, Issue (3), Pages 49-52, March,26 (2016)

Abstract

The work is aimed at developing an anti-surge control software for the Turbo-blower number 11 and 12 at Power And Blowing Station of Bhilai Steel Plant. Surge is the phenomenon in which there is a sudden increase in the discharge pressure of the blowers and hence the decrease in the flow rate which leads to the flow reversals. This flow reversal can cause severe damages to the blower turbine and can also be fatal for the human lives working over there. The work starts with studying the anti-surge control systems already installed at the blower Number 11 and 12. The present surge control system is hardware programmed, i.e., it is designed with the use of potentiometers, rectifiers, analog controller, etc. on a printed circuit board. Due to the aging and the involvement of the various circuit components there is always a possibility of control system failure due to the component failure. This project is intended to replace that hardware programmed circuit with a controlling software which will be designed and fed to a general purpose programmable single loop controller. It will decrease the probability of the system failure and hence will increase the reliability of the surge control system.

References

  1. N. Staroselsky and L. Ladin (1979)., Improved surge control for centrifugal compressors., Chemical Engineering, McGraw-Hill, Newyork, 86, 175-184.
  2. Willems F. and de Jager B. (1999)., Modeling and control of compressor flow instabilities., Control Systems Magazine, IEEE, 19(5), 8-18.
  3. Gravdahl J. T. (1998)., Modelling and control of surge and rotating stall in compressors, Ph. D. Thesis, Department of Engineering Cybernetics., Norwegian University of Science and Technology, Norway.
  4. Salim Al-Mawali and Jie Zhang (2007)., A Novel Fuzzy Logic Control Strategy for Compressor Surge Control Using a Variable Area Throttle., 22nd IEEE International Symposium on Intelligent Control, Part of IEEE Multi-conference on Systems and Control, Singapore, 1-3 October, 682-687.
  5. Liu Xiaoyang and Wang Ping (2013)., Anti-surge Control Technologies of Large–sized Chinese Gas Compression Pump., IJCSI International Journal of Computer Science Issues, 10(2).
  6. Ghanbariannaeenni Ali and Ghazalehsadat Ghazanfarihashemi (2012)., Protecting a Centrifugal Compressor from Surge., Pipeline and Gas Journal, 239(3).
  7. Mohamed A. Waly, Ibrahim F Tarrad and Mohamed M. Fouad (2014)., Surge Detection System for Centrifugal Compressor., International Journal of Engineering and Science Technology, Waly, 3(2), 692-698.
  8. Terje Kvangardsnes (2009)., Anti-surge control: Control theoretic analysis of existing anti-surge control strategies, Department of Engineering Cybernetics. Master thesis, Norwegian University of Science and Technology, Norway., undefined
  9. Wang Shenghui and Jin Xing (2010). A research on anti-surge and predictive control method of centrifugal air compressor., International Conference on Computer Application and System Modeling, 22-24, October, 2010, 3, 590-593., undefined
  10. Mohamed A. Waly, Ibrahim F. Tarrad and Mohamed M. Fouad (2014)., Surge Detection System Using Gaussian Curve Membership Function., International Journal of Advanced Research in Electrical, Electronics and Instrumentation Engineering, 3(11).
  11. Zhang Hua, Wang Taofen and wang Yigang (2012)., Antisurge Control of Compressors in Catalytic and Cracking Devices for Heavy Oil. 2nd International Conference on Materials., Mechatronics and Automation Lecture Notes in Information Technology, 15
  12. N. Staroselsky and L. Ladin (1979)., Improved surge control for centrifugal compressors., Chemical Engineering, McGraw-Hill, Newyork, 86, 175-184.
  13. Willems F. and de Jager B. (1999)., Modeling and control of compressor flow instabilities., Control Systems Magazine, IEEE, 19(5), 8-18.
  14. Salim Al-Mawali and Jie Zhang (2007)., A Novel Fuzzy Logic Control Strategy for Compressor Surge Control Using a Variable Area Throttle., 22nd IEEE International Symposium on Intelligent Control, Part of IEEE Multi-conference on Systems and Control, Singapore, 1-3 October, 682-687.
  15. Liu Xiaoyang and Wang Ping (2013)., Anti-surge Control Technologies of Large–sized Chinese Gas Compression Pump., IJCSI International Journal of Computer Science Issues, 10(2).
  16. Ghanbariannaeenni Ali and Ghazalehsadat Ghazanfarihashemi (2012)., Protecting a Centrifugal Compressor from Surge., Pipeline and Gas Journal, 239(3).
  17. Mohamed A. Waly, Ibrahim F Tarrad and Mohamed M. Fouad (2014)., Surge Detection System for Centrifugal Compressor., International Journal of Engineering and Science Technology, Waly, 3(2), 692-698.
  18. Terje Kvangardsnes (2009)., Anti-surge control: Control theoretic analysis of existing anti-surge control strategies, Department of Engineering Cybernetics. Master thesis, Norwegian University of Science and Technology, Norway., undefined
  19. Mohamed A. Waly, Ibrahim F. Tarrad and Mohamed M. Fouad (2014)., Surge Detection System Using Gaussian Curve Membership Function., International Journal of Advanced Research in Electrical, Electronics and Instrumentation Engineering, 3(11).
  20. Zhang Hua, Wang Taofen and wang Yigang (2012)., Antisurge Control of Compressors in Catalytic and Cracking Devices for Heavy Oil. 2nd International Conference on Materials., Mechatronics and Automation Lecture Notes in Information Technology, 15